When To Prune Oak Tree? Oak trees can be pruned at different maturity levels and this simple task can be easily done by the homeowner or property owner. Tree specialists and tree fellers should be excluded from this work as it requires specialist equipment and tree climbing experience, but homeowners and property owners can do this easily. In general, work is done on the larger upper branches and the smaller branches of the lower branches and the trunk are cut back.
Non-asphalt pruning sealant or exterior latex paint
Depending on the size of the branch to be cut, cutting tools of different sizes can be used. For smaller branches, for example, a throw saw without moving parts is suitable. Goggles or helmet to protect the head and eyes from falling debris and goggles or helmet to protect against the wind.
Basic Oak Pruning
Thinning removes dead branches and grapes from dead leaves and branches, and also crosses or rubbed branches should be removed.
If there are several oak forests, the crown placement can be described as creating a park or a walkable and drivable area. This gives the tree more light and air, while weaker branches absorb nutrients better, which are better absorbed by the healthier parts of the trees to be used by healthier parts.
Remove the area around the lower part of the tree and remove the lowest limb up to 8 feet and the upper limb up to 6 feet or less.
If the tree is less than 1.50 m high, it is advisable to raise the crown by one third of the total height, as this is also important for firefighting.
Before pruning every year, very young oaks should be planted in this area to bring the tree into the desired shape. In this reduction, it is called pruning of limbs and branches to make the trees smaller. This is as necessary to protect the trunk as it is to protect against pests such as squirrels and birds.
Cutting and Sealing Oaks
Then get as close as possible to the other branch and make a clean cut, but be careful not to cut off the remaining branch. Start by cutting the branch off at about 3 cm above the crossing, which you should cut off for larger branches. Then cut down a third of the way, then make clean cuts and get up and cut again.
Since oaks are prone to disease and harmful insects, it is important to close wounds on them. Caution is required with large branches, as their weight can break them off and leave sharp edges.
Use a non-asphalted sealant that has been specially developed for pruning trees, but latex paint can also be used. You can also use latex paints in combination with other sealants such as polyurethane, polyethylene glycol or polystyrene.
Timing is Important
This will help prevent the dreaded oak wilting disease, a systemic problem that once spread and was very difficult to stop until it spread. Oak trees are best pruned in the winter months of November to April, and oak wilting occurs when the tree is most sensitive during its growing season.
If the tree needs to be pruned or damaged during the growing season, the gardener should seal the wound with a protective sealant. This fungal disease is transmitted by an insect that transmits it and penetrates the bark through a wound.
When to Call a Professional
One should not use a ladder to prune a tree, and one should not use the ladders to prune a tree, but use hands and fingers.
If the budget does not allow the rent of the work, the homeowner should hire a professional to do the hard part and do some cleaning and minor work himself. If there are very large branches without simple pruning tools, a homeowner can ask the tree service for a quote.
